BOSCH PVA 2P500 PAVIRO Power Amplifier
SKU:307,500৳
The BOSCH PVA 2P500 PAVIRO power amplifier is a 2 x 500 Watt professional audio Class D-amplifier for evacuation purposes. It can be operated from both the mains and a DC supply.
- Floating 100 V or 70 V power outputs
- High efficient amplifier blocks in class-D technology
- Outputs idling and short circuit-protected
- Mains operation 120–240 V (50/60 Hz) and/or 24 V DC emergency backup
- Electronically balanced inputs
- Temperature monitoring function
- Pilot tone and ground fault monitoring function via PVA-4CR12 controller or PVA-4R24 router
- Processor control of all functions
- Monitoring of the processor system via watchdog circuit
- Non-volatile FLASH memory for configuration data
- Internal monitoring function
- Integrated audio relays
- Line monitoring function
BOSCH PVA 2P500 PAVIRO Power Amplifier Sprecs:
The PVA 2P500 benefits from the lowest power consumption of any system in its class, minimizing running costs and requiring fewer backup batteries too. The system is extremely flexible and allows architecture changes at any time during installation and has a wide range of announcement/music combinations.
Ideal for small to medium-sized offices, regional airports, mid-sized hotels, factories, schools, and department stores. It can be operated from both the mains and a DC supply. The output voltage is galvanically insulated and is constantly monitored for a ground fault. An energy-saving mode and temperature-controlled fans reduce energy consumption and noise levels.
The control and monitoring functions are performed via CAN bus. This amplifier is designed for operation in an emergency evacuation system. The amplifiers are usually controlled via a controller and configured using IRISNet.
| Rated load impedance (output power) | |
| • 100 V | 20 Ω (500 W) |
| • 70 V | 10 Ω (500 W) |
| Rated output power, 1 kHz, THD ≤ 1% | 2 ✕ 500 W1 |
| Rated input voltage | +6 dBu |
| Max. RMS voltage swing, 1 kHz, THD ≤ 1%, without load | |
| • 100 V | 110 V |
| • 70 V | 78 V |
| Voltage gain, ref. 1 kHz, fixed | |
| • 70 V | 33.2 dB |
| • 100 V | 36.2 dB |
| Maximum load capacitance | 2 μF |
| Input level, max. | +18 dBu (9.75 Vrms) |
| Frequency response, ref. 1 kHz, rated load, -3 dB | 50 Hz to 25 kHz |
| Input impedance, active balanced | 20 kΩ |
| Signal-to-noise ratio (A-weighted) | > 104 dB |
| Output noise (A-weighted) | < -62 dBu |
| Crosstalk , ref. 1 kHz | < -85 dB |
| Output stage topology | Class-D, transformer, floating |
| Power requirements | |
| • AC | 115–240 V (-10/+10%)2 |
| • DC | 21‑32 V |
| Power consumption, AC and DC | See section “Power consumption” in the operation manual |
| Inrush current | 2A |
| Inrush current, after a five-second power cycle | 1.3A |
| Mains fuse | T6.3A (internally) |
| DC fuse | 30A (internally) |
| Ground fault | R < 50 kΩ |
| CAN-BUS port | 2 ✕ RJ-45, 10 to 500 kbit/s |
| Protection | Audio input level limiter, RMS output power limiter, high temperature, DC, short circuit, mains Undervoltage protection, DC supply Undervoltage protection, inrush current limiter, ground fault |
| Cooling | Front-to-rear, temperature-controlled fans |
| Operating temperature | -5 °C to +45 °C |
| Safety class | Class I |
| Electromagnetic environment | E1, E2, E3 |
| Product dimensions (Width ✕ Height ✕ Depth) | 19”, 2 HU, 483 ✕ 88.2 ✕ 391mm |
| Net Weight | 16.5kg |
| Brand |
|---|
Related products
-
BOSCH PLE1ME240 Mixer Amplifier
108,550৳Add to cartThe BOSCH PLE1ME240 Mixer Amplifier amplifier is rated at 240 watts, with outputs available on a 100-volt line as well as 4 ohms. Four switchable mic/line balanced inputs are provided and phantom power is also available for condenser microphones.
Input 1 can be activated by contact closure on a push-to-talk paging mic, and this can take priority over all other microphone and music inputs. There is also a pre-announcement chime built in.
- A separate music input with volume control is also available.
- 4 microphone/line inputs, plus music source input
- Announcement only output, 3‑wire volume override
- Also available in 60 and 120-watt versions
- 2‑tone chime
-
ITC T-35M Mixer Amplifier
35,000৳Add to cartProduct Code: OTC2414
- 3 MIC inputs, 2 AUX inputs.
- 3 MIC volume control, 2 AUX volume control.
- With priority, MIC1 input is prior to other audio input.
- There is a separate treble and bass adjustment knob.
- One MIC2 / AUX1 selector switch, one MIC3 / AUX2 selector switch.
- ITC T-35M Mixer Amplifier includes two types of power output: 4 ohms constant resistance, 8 ohms output, and constant voltage 70V, 100V output.
- Single-channel rated power 35W output.
-
ITC T-650 Mixer Power Amplifier
66,500৳Add to cartProduct Code: OTC2427
The basic public address mixer-amplifier. It is featured with 3 microphone inputs, 2 aux inputs, and 1 EMC input. Priority muting is achieved via EMC for overriding other inputs except for Mic1 on the front panel.
Individual gain controls are provided for Mic 1-3 and Aux 1-2, bass and treble controls, and master volume control are provided for overall tone control. 70V, 100V, and low impedance 4-16 ohms speaker outputs are provided. Extensive protection from short-circuit, overload, and high temp.
Reviews
There are no reviews yet.