BOSCH PLE2CS Plena Call Station
SKU:35,700৳
The Bosch Plena PLE-2CS 2 zone paging microphone is a high-quality call station with a sturdy metal base designed for use with the PLE series of amplifiers such as the Bosch PLE-2MA120 and PLE-2MA240. In addition to tabletop use, the special design of the PLE2CS enables the unit to be neatly flush-mounted. 2 zone selection keys enable either or both zones to be selected for paging – indicated by LEDs.
- Modern two-zone call station for the PLE series
- Selectable gain
- Speech filter and limiter
- Output level control
- Loop-through option for up to 8 call stations
- LED indications for zone selection, busy, and power on
BOSCH PLE2CS Plena Call Station Specs:
- Voltage Range: 24 VDC supplied by PLE mixer amplifier or mixer
- Current Consumption: <30 mA
- Nominal Sensitivity: 85 dB SPL (gain preset 0 dB)
- Nominal Output Level: 700 mV
- Maximum Input Sound Level: 110 dB SPL
- Gain Preset: +6 / 0 / -15 dB
- Limiter Threshold: 2 V
- Compression Ratio Limiter: 1:20
- Distortion: <0.6% (maximum input)
- Equivalent Input Noise Level: 25 dB SPLA
- Frequency Response: 100 Hz – 16 kHz
- Speech Filter -3 dB @ 315Hz, high-pass, 6 dB / oct
- Output Impedance: 200 ohm
- Chimes – 6
| Brand |
|---|
Related products
-
BOSCH LBB1938 Power Amplifier
133,000৳Add to cartThe Bosch LBB 1938/20 is a powerful 480 W power amplifier in a 3U high 19”case for rack mounting or tabletop use.
LEDs on the front panel of the LBB1938/20 show the status of the amplifier: power, audio output level, and supervised functions.
This high performance unit fulfills a wide range of public address requirements at a surprisingly low cost.
There are two separate priority controlled 100 V outputs for zones that only need announcements made via the priority input, and for zones that will not get any announcements made via the priority input.
Rack mounting brackets supplied.
- 480 watts
- Very high audio performance power amp
- Can be used to boost Plena Voice alarm systems with system monitoring
- XLR and jack input with XLR and Jack loop through outputs
- 100 volt line input. Ideal for remote location booster amps
- 100v, 70v and 8 ohm outputs
- 24v override relay output
- Temperature controlled fan
- AC and 24VDC operation
- LED VU Meter
- Dual inputs with priority switching
- Temperature controlled forced front to back
- Mains, battery back-up, and pilot tone supervision
- TÜV certified according to IEC 60849
-
BOSCH PLE1CS Plena Call Station With 6 Zones
48,800৳Add to cartThe BOSCH PLE1CS Plena call station paging microphone is a stylish design high-quality call station with a stable metal base, a flexible microphone stem, and a unidirectional condenser microphone. The LBB1956/00 can make calls to selected zones (one to six and all-call) in a public address system built with the Plena Voice Alarm System. In addition to tabletop use, the special design allows it to be neatly flush-mounted on desktops.
- Stylish six-zone call station for the Plena Voice Alarm System
- Uni-directional condenser mic on a flexible stem
- Six zone selection keys, all-call key, and momentary PTT-key for calls
- Selectable gain, speech filter, limiter, and output level for improved intelligibility
- LED indications for zone selection, fault, and emergency state
- Call station extension provides seven additional zone and zone group keys
- Allows connection of expansion keypad LBB1957
-
BOSCH LBB 4430/00 Call Station Basic
49,500৳Add to cartProduct Code: OTC2471
The call station basic can make manual or prerecorded announcements to any pre-assigned zones. The call station basic has a microphone on a flexible stem, a push-to-talk button, a speaker, and a headset socket. The LBB 4430/00 can be extended with up to 16 keypads (LBB 4432/00 or LBB 4434/00), each with eight programmable keys. Extension with a numeric keypad (PRS-CSNKP) is also possible. The call station has a cardioid, supervised microphone on a gooseneck stem with good speech intelligibility.
-
BOSCH Plena PLE1CS Call Station
20,000৳Add to cartThe Plena PLE-1CS tabletop unidirectional condenser paging microphone is a high-quality call station with a sturdy metal base designed for use with the BOSCH PLE series of amplifiers. In addition to tabletop use, the special design enables the unit to be neatly flush-mounted.
The PLE1CS microphone features a large press to talk call button for ease of use and the flexible gooseneck enables the microphone to be positioned as required. A green LED confidence light illuminates to let you know the mic is in use.
- PTT-key for calls for activation
- Momentary or toggle
- Green LED, indicating microphone active
- Stable metal base design with fixed 2 m cable and lockable Euro-style connector
- Phantom powered by the amplifier
Reviews
There are no reviews yet.