BOSCH PLE1CS Plena Call Station With 6 Zones
SKU:48,800৳
The BOSCH PLE1CS Plena call station paging microphone is a stylish design high-quality call station with a stable metal base, a flexible microphone stem, and a unidirectional condenser microphone. The LBB1956/00 can make calls to selected zones (one to six and all-call) in a public address system built with the Plena Voice Alarm System. In addition to tabletop use, the special design allows it to be neatly flush-mounted on desktops.
- Stylish six-zone call station for the Plena Voice Alarm System
- Uni-directional condenser mic on a flexible stem
- Six zone selection keys, all-call key, and momentary PTT-key for calls
- Selectable gain, speech filter, limiter, and output level for improved intelligibility
- LED indications for zone selection, fault, and emergency state
- Call station extension provides seven additional zone and zone group keys
- Allows connection of expansion keypad LBB1957
BOSCH PLE1CS Plena Call Station With 6 Zones Specs:
Controls and indicators
- Four status LEDs
- PTT-key
- PTT status LED
- Six zone selection keys
- Six zone selection LEDs
- All-call key
- Eight DIP switches
- Rotary volume control
Interconnections
- Two RJ45 jacks
- 24 VDC input
- Keypad connector
| Brand |
|---|
Related products
-
ITC T-6760 Rack Mount Network Audio Adapter Power Amplifier
104,160৳Add to cart- IP network audio adapter built-in digital class-D 60W, 120W, 240W & 350W amplifier.
- Direct to receive internet audio source and transmit to 70V, 100V, and low impedance loudspeakers.
- Non-dedicated network system solution.
- Could be installed anywhere of the LAN network.
- Economy network audio solution for multiple speaker applications.
- With a 3.4 inch LCD screen humanized operation interface.
- Zone definition is done through software, each network audio adapter could be regarded as one zone, or several audio adapters could be taken as one zone, moreover, several zones could be defined as a group for synchronous operation.
- One Aux input and one local microphone input, both with volume control.
- Remote control over IP address change and write-in, volume control, and local program selection from the server.
- Voice evacuation system with higher priority and local input with secondary priority. Moreover, the local input and program source priority could be customized
-
ITC-t-6701 Rack Mount Network Audio Adapter Power Amplifier
35,500৳Add to cart- 19 rack mount IP/TCP network audio adapter in 2U height
- ITC-t-6701 amplifier built-in single-channel TCP/IP decoder
- Decode digital audio data to analog amplifier
- Heart of IP background music, zone paging & voice alarm system
- Built-in 3.4 inch LCD screen displays the IP address and status in English
- Supplied a remote control over music selection, IP address change and volume attenuation
- A serial IP address write in communication port
- Numeric keys on the front panel for convenient operation
- 4 channel line outputs to amplifiers
- 4 channel 100V speaker inputs loop and 4 channel 3 wired volume control inputs
- 1 external line input (with volume control) and microphone input
- Automatically power off when no input for 5 minutes and automatically power on when
- signal feed into
- Pre-set power management
-
BOSCH LBB1938 Power Amplifier
133,000৳Add to cartThe Bosch LBB 1938/20 is a powerful 480 W power amplifier in a 3U high 19”case for rack mounting or tabletop use.
LEDs on the front panel of the LBB1938/20 show the status of the amplifier: power, audio output level, and supervised functions.
This high performance unit fulfills a wide range of public address requirements at a surprisingly low cost.
There are two separate priority controlled 100 V outputs for zones that only need announcements made via the priority input, and for zones that will not get any announcements made via the priority input.
Rack mounting brackets supplied.
- 480 watts
- Very high audio performance power amp
- Can be used to boost Plena Voice alarm systems with system monitoring
- XLR and jack input with XLR and Jack loop through outputs
- 100 volt line input. Ideal for remote location booster amps
- 100v, 70v and 8 ohm outputs
- 24v override relay output
- Temperature controlled fan
- AC and 24VDC operation
- LED VU Meter
- Dual inputs with priority switching
- Temperature controlled forced front to back
- Mains, battery back-up, and pilot tone supervision
- TÜV certified according to IEC 60849
-
BOSCH LBB 1990/00 Plena Voice Alarm Controller
228,000৳Add to cartThe Plena LBB 1990/00 Voice Alarm Controller unit, is the heart of the voice alarm system. It is the basis of the Plena Voice Alarm System and has all the essential functionality for compliance with the EN54‑16 and EN60849 standards, including full system supervision, loudspeaker line impedance supervision, a supervised emergency microphone on the front panel, and a supervised message manager.
The LBB1990/00 enables messages to be merged to allow even more flexible use of pre-recorded announcements and evacuation messages. The controller can be used as a stand-alone system with up to six zones or expanded to up to 120 zones using additional six-zone routers.
Up to eight call stations can be connected. Interconnections are made using standard RJ45 connectors and shielded CAT-5 cable.
A built-in 240 W amplifier provides the power for the emergency call channel and BGM. Additional Plena Amplifiers can be added to provide two-channel operation. All amplifiers are supervised. The audio output uses standard analog audio 100 V line switching for full compatibility with the Plena family of public address equipment and Bosch EVAC-compliant loudspeakers. The system is configured using DIP switches for basic functionality and a PC for more advanced functions.
- Basic 6 zone system
- Expandable to 60 zones
- Up to 8 call stations can be connected
- Built-in 240 watt booster amp
- Digital message system
- Up to 255 pre-recorded messages and chimes/tones can be stored
- The emergency mic on the front panel
- 16 priority levels
- Individual BGM control for each zone
- Standard and emergency control in and outputs
- Additional Booster amps are supervised
- Can be set up using PC or via DIP switches
- Fully complies with IEC60849 and all national equivalents
Reviews
There are no reviews yet.